Open Source Ecology
Project Development Channels / cnc-torch-table-stuff
Eric Lotze
11/27/2021 2:40 AM
Made some comments on this video:
https://www.youtube.com/watch?v=wg63_VdCo7c
Marcin Jakubowski
CNC Torch Table Cuts - v21.08
2:40 AM
I need to make a page on "Dross" and "Kerf" later
2:41 AM
Some related link spam:
https://www.researchgate.net/post/How_to_measure_the_dross_formation_for_laser_cutting_process
https://www.mate.com/technical-resources/tips-techniques/laser-cut-quality-guide
Devin Sundquist
Laser Cut Quality Guide - Mate Precision Technologies
Optimize the cut quality for any material using the following steps: Use the closest known settings to the material you are trying to cut. Verify that
2:41 AM
Eric Lotze
11/27/2021 2:51 AM
Seems
@Ken Makunga
has already done some of the documentation i was thinking of!:
https://www.youtube.com/watch?v=xwabDgqGA8M
Ken Makunga
OSE Apprenticeship and Summer of Extreme Design and Build 2021
2
2:52 AM
and is all this essentially just discussed in the meeting, i feel like that is where probably all the discussion on this is, so 2/3 of my questions may already be answered
Exported 6 message(s)
Timezone: UTC+1
2