Square tube for handles

11:50 AM

@Fritz @easymoulds i agree round bar is better for ergonomics, but is it worth getting 2 different types of tubes for 1 machine? since in most places they sell them by 6 m UNLESS you use the same tube size than the barrel, then imo makes sense, otherwise, not really

also could this be simplified to 3 levers instead of 5?

Carolina

also could this be simplified to 3 levers instead of 5?

Could be, but if you keep the arm length the same you would have to reach quite far. For this lever length, the reaching distance from one to the next lever is 0.75m, whereas with 3 levers this would be 1.30m

1:23 PM

This is the data I could find on the reaching depth, which is why I came to 5 arms

1

Could be a differentiation between the basic and advanced/pro as well? To use a shorter lever length at the basic model - but at the same time quite crucial for the performance..

Carolina

@Fritz @easymoulds i agree round bar is better for ergonomics, but is it worth getting 2 different types of tubes for 1 machine? since in most places they sell them by 6 m UNLESS you use the same tube size than the barrel, then imo makes sense, otherwise, not really

Its already using 3m for one wheel - if you are in a country with hardware stores you can buy them in 1-3m length